ASTM D1037 PDF

You are on page 1of 30 Search inside document Standard Test Methods for Evaluating Properties of Wood-Base Fiber and Particle Panel Materials1 This standard is issued under the xed designation D ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. They are divided into two parts.

Author:Goltill Dagar
Country:Rwanda
Language:English (Spanish)
Genre:Medical
Published (Last):11 April 2007
Pages:196
PDF File Size:15.87 Mb
ePub File Size:9.85 Mb
ISBN:800-6-81195-445-8
Downloads:11577
Price:Free* [*Free Regsitration Required]
Uploader:Zulkihn



The properties range from size and appearance, to tensile, compression, and shear strengths, as well as hardness, water absorption, and fastener holding.

The information included on this page will focus on the mechanical tests within ASTM D that are the most common and best performed on a universal testing machine to identify typical mechanical properties. Mount the specimen in a 3-point center loading fixture. Selection of the proper fixture span, supports, and loading nose will depend on specimen size and condition. Apply load to the center of the specimen at the constant rate of speed calculated from the equation in the standard.

Continue the test until rupture, while recording all force vs. Typical Calculations: Modulus of Rupture, Stiffness Apparent Modulus of Elasticity Tensile Strength Parallel to Surface dog-bone specimens Prepare the specimens as described in the test method — using dog-bone shapes cut from both directions with respect to original board, in dry and soaked conditions.

Mount the specimens in self-aligning and self-tightening grips. Apply a tensile load at the constant rate of speed specified in the standard. Continue loading until failure. Calculations: Max Load, Max Stress Tensile Strength Perpendicular to Surface block-type specimens Prepare the specimens as described in the test method — dry condition only. Bond the test specimen to test blocks on both sides and mount the assembly into the appropriate loading fixtures. Prepare the specimens as described in the test method and selected procedure — both in the dry and soaked conditions.

Load the specimens into the test machine, centered underneath a spherically seated compression platen. Apply a compressive load at the constant rate of speed specified in the standard.

LIBRO COMUNICACION ESTRATEGICA DANIEL SCHEINSOHN PDF

ASTM D1037 PDF

Inspection Validating the specifications, value and safety astmm your raw materials, products and assets. Continue the test until rupture, while recording all force vs. Link to Active This link will always route to the current Active version of the standard. Cellulosic Fiber Insulating Board A.

EUROTHERM 425S PDF

ASTM D1037 Wood-Base Fiber and Particle Panel Strength Testing

.

ENCICLOPEDIA DE ARQUITECTURA PLAZOLA VOLUMEN 6 PDF

ASTM D1037

.

Related Articles