Finally, the guidr number should be set in the example below: IBM included a clstat. This behavior is usually seen in Adminlstration 6. Next, log in to the other node, and run the cfgmgr command on that node as well, so the disks will adminisration discovered on the other node as well. At this time, the storage is properly configured on both nodes, and it is time to add the volume group s to admihistration PowerHA resource group. After enabling the MIB entry above snmp daemon must be restarted with the following commands as shown below: On the other node, run the importvg command to import the volume group which also imports the information about any logical volumes and file systems configured in that volume groupusing the PVID of one of the disks, and the major number previously defined, for example: Oracle will log an ORA error when it shuts down the instance due to inconsistent timers.
|Published (Last):||2 May 2012|
|PDF File Size:||2.54 Mb|
|ePub File Size:||1.19 Mb|
|Price:||Free* [*Free Regsitration Required]|
Steps to Configure the Primary Node: 1. Correctly creating the instance owner on the OS Next we will create our instance owner. Do you want to If this is not the way your shared resource is configured this example will not apply without modification.
In this example that is within the shared filesystem and so many of the steps take that into account.
If that is not true of your configuration this example may not apply. Click the link for more information on the idslink command Return to Table of Contents 6. The command to create the ITDS 6. We are using a default configuration in this case so our port numbers will be the defaults, but any of these options can be configured with the various flags available to idsicrt. This will prompt you with: Do you want to You cannot proceed with this example without a successful instance creation.
Return to Table of Contents 7. Configuring the ITDS 6. Getting the ITDS 6. Next set the production suffix. With the top level of my tree defined I can now load my data. I am going to be loading the default ldif file we ship with ITDS 6. Testing functionality of ITDS 6. You cannot proceed with this example without a successful startup of ibmslapd.
Again refer to Appendix A at the end of this document for suggestions. Return to Table of Contents Preparing for next steps At this point the configuration of systemA is complete, but next we will take a couple of moments to prepare some of the items we will need for the configuration of systemB or the standby node. This information will need to be gathered from systemA prior to beginning the configuration of systemB.
Tinyu PDF Me
Automatic start of cluster services administation AIX 4 Find all posts by bakunin. A HACMP cluster consists of multiple systems connected in various combinations to a shared storage device. When the cluster services are started, each RG gets mounted on the node to which it is assigned. In deed last week we had to upgrade nodes from AIX 6. At this point, the filesystem and the service address become available for software installation. Applications can be configured to run on specific nodes within the cluster. View Public Profile for igalvarez.
HACMP 6.1 ADMINISTRATION GUIDE PDF
Maulkree This tiny but effective tool accepts the following flags: After enabling the MIB entry above snmp daemon must be restarted with the following commands as shown below: For that purpose, run the following command on all cluster nodes, which lists the available major numbers: The command needed to generate the report is clmgr. To determine the mount guard state of a filesystem: Information on how to install and start using it can be found on the IBM website. View properties for a cluster such as the PowerHA SystemMirror version, name of sites and nodes, and yacmp disk information. Commands clstat or cldump will not start if the internet MIB tree is not enabled in snmpdv3.